Menu

Products

Go back to catalogue

PAG 220 Synthetic Gear Lubricant

PAG 220 Synthetic Gear Lubricant

PAG Synthetic Gear Lubricants are a range of Polyalkylene Glycol base synthetic fluids, which provide outstanding load carrying properties and excellent thermal stability.


Product Code: 14230
Features

Purpose designed to provide excellent corrosion protection (ASTM D665, procedure B pass) and demulsibility characteristics (ASTM D1041)
Allow thermally stable operation at temperatures in excess of 200°C
Typical applications include the lubrication of calendars, and bevel, spiral bevel, helical, enclosed spur and worm gear units. The lubricants are free of sulphur, chlorine and lead based additives
Remain homogenous from below their pour point to temperatures in excess of 250°C
The anticipated service lifetime of all grades is substantially in excess of 10,000 hours at 100°C in industrial enclosed gear units, the performance allowing for extended drain intervals and, in some cases, for operation as a “Fill for Life” lubricant
General approval has been given for this lubricant range as a Type “G” lubricant in David Brown industrial enclosed gear units

Flushing Procedures

When changing from mineral oil to PAG Synthetic Lubricant the following procedure should be followed:
Run system until the mineral oil is warm, then drain as fully as possible, particular attention being paid to reservoirs, lines etc, where oil may be trapped.
The system should be cleared of any residual sludge.
Flush the system with the minimum quantity of PAG by operating under no load, then drain the system whilst the fluid is warm. Repeat if necessary.
Seals, etc., should be inspected and if deteriorated then replaced.
Seals previously exposed to mineral oils may shrink when exposed to PAG, and therefore it may be advantageous to replace them.
Fill system with PAG. It is useful to inspect the lubricant after one or two days in use to make sure that it is free of extraneous materials. Contamination with significant quantities of other lubricants can, in some cases, lead to sludging, foaming and other problems.

Materials Compatibility

Polyurethane based elastomers, leather, cork, asbestos, paper and board should be avoided.
Common seal and gasket materials are unaffected by PAG. Nitrile Rubber (NBR),
Fluoro-Silicone or Vinyl-Methyl Polysiloxane (Q) is recommended especially where high temperatures are involved.
Ordinary industrial paints soften in the presence of PAG. Internal gearbox surfaces should ideally be unpainted, or coated with resistant two-pack epoxy formulations PAG must never be mixed with mineral oil, and ideally not mixed with other polyglycol lubricants in order to preserve their anti-corrosion and sea water demulsification properties.

Please Note: The product images shown are for illustration purposes only and may not be an exact representation of the product.
Pack Sizes
Depending on the range, Rock Oil products are available in multiple sizes, including 400ml aerosols and 1L / 4L / 5L / 20L / 210L / bulk containers.
menuchevron-leftcross-circle